C P - 2 0 4 4 CONNER NO MORE PRODUCED Native| Translation ------+-----+-----+----- Form 2.5"/SUPERSLIMLINE Cylinders 548| 980| | Capacity form/unform 42/ MB Heads 4| 5| | Seek time / track 15.0/ 2.0 ms Sector/track 38| 17| | Controller IDE / AT Precompensation Cache/Buffer 32 KB Landing Zone 980 Data transfer rate 1.500 MB/S int Bytes/Sector 512 4.500 MB/S ext Recording method RLL 2/7 operating | non-operating -------------+-------------- Supply voltage 5 V Temperature *C 5 55 | -40 60 Power: sleep 0.2 W Humidity % 8 80 | 8 80 standby 0.3 W Altitude km -0.061 3.048| 12.192 idle 1.5 W Shock g 10 | 100 seek 2.5 W Rotation RPM 3486 read/write 2.5 W Acoustic dBA 34 spin-up W ECC Bit MTBF h 150000 Warranty Month 12 Lift/Lock/Park YES Certificates ********************************************************************** L A Y O U T ********************************************************************** CONNER CP2044 CUSTOMER OPTIONS +------------------------------------------------------+ | +-+ MS+++CD |X44 | | | +++ I |XX Power | | | N |XX +5V 41/42 | +-+ T |XX GND 43 | E |XX | R |XX | F |X* Position | A |XX 20-Key | C |XX | E |XX | |XX | |XX | |1X | |XX Factory | |XX test +------------------------------------------------------+ points ********************************************************************** J U M P E R S ********************************************************************** CONNER CP2044 CUSTOMER OPTIONS Jumper setting -------------- M/S C/D Master/Slave ----------------------- M/S C/D For Master (C Drive) when M/S is CLOSED, place +-+ Jumper as shown. |*| * |*| * +-+ M/S C/S If Master/slave feature is selected at Pin 28 of the interface/power connector, jumper M/S should be * * left open as ashown. +-----+ |* *| +-----+ The CP2044 drives are designed to operate either as a Master drive (C Drive) or a Slave Drive (D Drive). This feature is dependent on two drive settings; the status of hardware Jumper M/S and the firm- ware setting of a feature bit. When (M/S) is closed, and the feature bit is set, the drive will assume the role of a Master Drive. When M/S is open, and the feature reset, the drive will act as the Slave. In single drive configurations M/S must remain in the closed position. ********************************************************************** I N S T A L L ********************************************************************** CONNER CP2044 CUSTOMER OPTIONS Mounting Holes -------------- Side: 3 mm x 0.5 mm THD (4x) 4 mm Max. Insertion Bottom: 3 mm x 0.5 mm THD (4x) 4 mm Max. Insertion