D P L A - 2 4 4 8 0 T R A V E . 5 G S IBM
Native| Translation
------+-----+-----+-----
Form 2.5"/SUPERSLIMLINE Cylinders | 9264| |
Capacity form/unform 4480/ MB Heads | 15| |
Seek time / track 12.0/ 4.0 ms Sector/track | 63| |
Controller IDE / ATA3 Precompensation
Cache/Buffer 96 KB Landing Zone
Data transfer rate 9.000 MB/S int Bytes/Sector 512
16.600 MB/S ext
Recording method operating | non-operating
-------------+--------------
Supply voltage 5 V Temperature *C 5 55 | 65
Power: sleep 0.1 W Humidity % 8 90 | 5 95
standby 0.3 W Altitude km -0.300 3.000| -0.300 12.000
idle 1.3 W Shock g 100 | 400
seek W Rotation RPM 4900
read/write 2.5 W Acoustic dBA
spin-up 5.0 W ECC Bit
MTBF h
Warranty Month
Lift/Lock/Park YES Certificates
**********************************************************************
L A Y O U T
**********************************************************************
IBM DPLA TRAVELSTAR 5GS JUMPER SETTING
+--------------------------------------+
| |
| |
| |
+--------Interface-------------49------+
| **********************1 **47 Jumper
| *************x********* **48 |
+------44----------------------50------+
+ +
Pin position 20 is left blank for secure connector insertion.
**********************************************************************
J U M P E R S
**********************************************************************
IBM DPLA-24480/25120 TRAVELSTAR 5GS JUMPER SETTING
Jumper Setting
==============
Drive Address Setting
---------------------
A jumper is available at the interface connector to determine the
drive address.
Using Cable Selection, the drive address depends on the condition of
pin 28 of the AT interface cable. In the case when pin 28 is ground
or low, the drive is a Master. If pin 28 is open or high level, the
drive is a Slave.
---49--47+
* * * | Master
* * * | (Default setting)
---50--48+
---49--47+
* * X | Slave
* * X |
---50--48+
---49--47+
* * * | Cable Selection
* xxx |
---50--48+
---49--47+
* xxx | RESERVED (MASTER)
* * * |
---50--48+
---49--47+
* X * | NEVER ATTACH A JUMPER HERE!
* X * |
---50--48+
**********************************************************************
I N S T A L L
**********************************************************************
-ANY DIREC.
Notes on installation
=====================
Installation direction
----------------------
horizontally vertically
+-----------------+ +--+ +--+
| | | +-----+ +-----+ |
| | | | | | | |
+-+-----------------+-+ | | | | | |
+---------------------+ | | | | | |
| | | | | |
| | | | | |
+---------------------+ | +-----+ +-----+ |
+-+-----------------+-+ +--+ +--+
| |
| |
+-----------------+
The drive will operate in all axis (6 directions).